Iomega PC4B/50
@5FCB.ADF - Iomega PC4B/HD SCSI Host Adapter Board
@7FF9.ADF - IOMEGA PC4 Host Adapter Board 
@7FFA.ADF - Iomega PC4B/50 SCSI Host Adapter Board 

os2v234.exe Iomega Tools for OS/2
FTP Iomega Software FTP
ADF for PC4B/50

J2 DB37 Male
J5 Termination?
RP1-3 Resistor paks
U2 NCR 26C64L-10
U6 NCR 86C01
U7 NCR 01148000
U15 16.000000 MHz osc

AdapterId 7FFA Iomega PC4B/50 SCSI Host Adapter Board

I/O Address Select
   I/O address used by PC4B/50
      <"240" (io 00240h-0025Fh)>, 340 (0340-035F), 400 (0400-041F), 420 (0420-043F), 3240 (3240-325F), 8240 (8240-825F), A240 (A240-A25F), Disabled

DMA Level Select
   The PC4 supports the direct memory access (DMA) mode of data
transfer.  Most operating systems require this option to be
enabled.  Each DMA level has a corresponding priority level;
the lower the DMA level, the higher the corresponding priority.
      <"DMA Level 5">, 6, 7, DMA Disabled

   If 'Fairness' is enabled, the PC4 adapter will not compete for the channel during the next arbitration phase if it is currently in control of the channel.  This allows other installed adapters to obtain the channel in the next sequence based on each adapter's assigned priority level.  When 'Fairness' is disabled, the adapter will compete for every arbitration phase and will obtain more than its fair share of channel usage. 
      <"Fairness Enabled">, Fairness Disabled

IRQ level
   Operation with multi-tasking operating systems may require the use of an IRQ signal when the PC4 requires processor service. No other adapter may be assigned the same IRQ level as the PC4. For DOS-only systems, this option may be disabled. 
      <"IRQ 7">, 5, 3, 9, IRQ Disabled

Memory Address Select
   You may set the PC4 adapter to any one of the Memory Addresses
listed.  The first choice is recommended for systems with a fixed
disk installed. 
      < "Disabled">, D400 (d400-d5ff), D200 (d200-d3ff), D000 (d000-d1ff), CE00 (ce00-cfff), CC00 (cc00-cdff), CA00 (ca00-cbff), C800 (c800-c9ff)

9595 Main Page